Pve Nas Disk Standby Hdparm Only Standby Short Time. VMware群辉迁移PVE_NAS存储_什么值得买 According to Proxmox, it only applies to storeage configured in /etc/pve/storage.cfg Additionally, I tried smartctl -i -n standby /dev/sda
VMware群辉迁移PVE_NAS存储_什么值得买 from post.smzdm.com
root@Sheevaplug:~# hdparm -S242 /dev/sda /dev/sda: setting standby to 242 (1 hours) root@Sheevaplug:~# hdparm -S /dev/sda -S: bad/missing standby-interval value (0..255) The command is accepted without any error, but then querying for its value returns bad/missing value and the drive keeps spinning down after only few seconds of inactivity. The only thing you need to know before getting started is the path to the drive's device file that you wish to configure standby settings for.
VMware群辉迁移PVE_NAS存储_什么值得买
This wouldn't be the first time the HDD vendors fudged specs However, when I turn Standby on and set a timeout, the drive never goes into standby. This wouldn't be the first time the HDD vendors fudged specs
How to Automatically Spin Down HDD on Raspberry Pi. The other 2 disks are ext4 and it's 2-3 months since these disks were formated so I doubt ext4lazyinit is the problem Adjust HDD standby time with hdparm Check the hdparm examples below to see how you can adjust the standby mode of the HDDs on your system
HotStanby Mode vs. ActiveStandby Mode DrayTek. Now I'm affraid the hdparm program is not compatible with my disks anymore For servers, using either method may impact performance, so it's typical for both to be disabled (which is my current goal here)